Home and zero#

Run won't start until X, Y and Z are zeroed on the stock.

Home (if you have limit switches)#

Under Home & Zero, click Home → All.

No limit switches? Untick Limit switches in the section header.

Zero#

1. Read the line under the buttons. It says where to zero (from Setup).
2. Jog the bit to that corner of the stock.
3. Click Zero → X and Zero → Y.
4. Jog Z down until the bit touches the surface, or use a touch plate.
5. Click Zero → Z.

A ✓ appears beside each zeroed axis.

Zeros cleared?#

Disconnecting, disabling motors or an alarm clears the ✓ marks. Home that axis again. If nothing changed, the ✓ comes back. Otherwise zero again.

Changed the bit? Always zero Z again.

Go back to zero#

Click Go → Safe Z, then X0 Y0.

Related: Where zero is